(i) has been trained in the use of the specific make and model of the tool to be used and is in possession of a valid operator’s certificate, (a) no employee operates a powder actuated tool unless the employee Under this federal legislation, a permit or license may be required.įor additional information contact: Explosives Regulatory DivisionĮastern Region: Quebec, Nunavut, and Atlantic Provinces Powder actuated tool blanks are also regulated by the Canada Explosives Act under the Explosives Regulation in Part 12. (c) knowledgeable about the hazards related to using the powder actuated tool.įinally, the powder actuated tool and its explosive charges must be properly stored in an area only accessible to authorized employees. (b) knowledgeable about Sections 87 to 89 of the General Regulation 91-191 and

(a) qualified, by completing the training required to obtain an operator’s certificate and being able to demonstrate knowledge of the tool With respect to powder actuated tools a competent operator would be: (c) knowledgeable about potential or actual danger to health or safety connected with the assigned work (b) knowledgeable about the provisions of the Act and the regulations that apply to the assigned work, and (a) qualified, because of such factors as knowledge, training and experience, to do assigned work in a manner that will ensure the health and safety of persons, In addition, the authorized employee(s) must be competent to use the tool.

They should be operated with the same precautions as firearms.Īn employer must ensure employees have a valid operator’s certificate and must authorize employees to operate a powder actuated tool. In some circumstances, federal legislation requires licensing for the storage and use of the explosive charges used in these tools (see Additional Information below).Ī powder actuated tool (also known as a Hilti gun or Ramset gun) by definition uses an explosion to propel and discharge fasteners. The certificate is valid only for the make and model of the specific tool. Certificates are normally provided by the tool’s supplier or manufacturer following training. However, they must have a valid operator’s certificate. Issued by: Director, Compliance and Regulatory Reviewĭo you need a license to operate powder actuated tools?Įmployees do not need a “license” to operate a powder actuated tool. Topic: Powder Actuated Tools – Operator Certificates

Hilti powder actuated training